Read reviews for the Prospector 16 by Nova Craft Canoe as submitted by your fellow paddlers. All of the reviews are created and written by paddlers like you, so be sure to submit your own review and be part of the community!
When the canoe arrived at Totem the outwale at the stern, LHS was not flush with hull but was sprung out ~ 1”. Totem tried to fix this by inserting another screw into he deck plate further towards the stern to pull the outwale in. This still left the outwale sprung from the hull ~ 1/4", plus I now had an extra countersunk hole in the outwale. Given the choice of shipping the thing back to London Ontario and waiting several weeks for delivery of a repaired or new canoe, I chose to take the 10% discount on the purchase price offered by Novo Craft.
The first winter, as per the Nova Craft instruction booklet, "Storing Your Canoe" section, I removed the first "8 or 10 screws from each end of both gunwales" and removed the deck screws and lifted the ends of the inwales above the hull in order to allow for the difference in shrinkage between the hull and the wooden gunwales due to low temperature. When I did this I found that the inwale was split at each screw hole, apparently because Nova Craft had failed to drill pilot holes through the inwale to accommodate the screws. I also found that one of the screw holding the outwale had missed the inwale completely.
Furthermore, in researching the Novo Craft "Care of Gunwales" where they recommend that the woodwork be treated with Tung Oil "three or four times a year", I found that Tung Oil is a furniture finish and hardly suitable for protecting/waterproofing wood for outdoor service. In fact the Lee Valley brochure on Tung Oil states that in order to get Tung Oil treated wood to a water resistant state, one must apply 10 coats of Tung Oil, with 24 to 48 hours drying time between coats. It's supposed to be a canoe, not a dining table! Also, Nova Craft does not mention the issue with the untreated wood between the hull and the inwale or outwale, which is well known to trap water and never dry, leading to rot. The only way around that issue is to either remove the inwales and outwales and treat the inside surface as well or to seal these surfaces from water ingress completely.
This year, August 2016, I removed all the woodwork for Tung Oiling and repair of the split inwales I also removed the bow and stern wooden carrying handles. To my dismay I found that the screws through the inwales into the carrying handles only penetrated the handles by 1/4". While this may hold the handles in place for a straight upward pull it is not a robust attachment for pulling forward or backward or for attaching a bow and stern line for holding the canoe in place when car topping.
I would rate the workmanship on these canoes as "no pride" and the serviceability of these canoes as 2 to 3 seasons-sunshine only. Either that or I was unlucky enough to pay $2114 for a canoe made on either a Friday or a Monday.
We use Tung oil on our ash gunwales because we found that using a waterproof finish such as spar varnish led to more problems when water that did get into the wood could not escape causing the wood to rot prematurely. The oil finish is more maintenance but they last longer. You didn't mention where you have stored your canoe but we definitely recommend ash trimmed canoes be stored inside out of the elements when not in use.
I'm not sure whether your canoe was damaged in shipping but Totem and Nova Craft did offer a discount which you accepted. As well the trim has worked for you for 10 seasons even with taking it apart in the winter to prevent frost cracks. While you have it completely apart perhaps you would like to replace the trim with aluminum gunwales which are more maintenance free. If you email me at firstname.lastname@example.org we can work out the details.
You didn't mention how your canoe has been for paddling. I hope you have enjoyed paddling it as much as the other reviewers on this site. Ignoring any resale value, after 10 seasons it has cost you $211.40 per year. I'm sure with the care you are taking with your canoe it will last you easy another 10 or 15 years. Really not too bad of an investment.
If you would like to replace the trim or discuss any other matters concerning your canoe, please drop me a line at the above email and we will do our best to look after you.
Tim Miller - Nova Craft Canoe
I just picked up my 16' Prospector in Aramid lay up and have been absolutely thrilled. I first put it in the water with my wife and we paddled it tandem. It tracked just as straight as an arrow and required very little adjustment. Then I took it out solo and it was a dream. The additional rocker over my previous tripping canoe was a vast improvement.
The staff at the London Paddle Shop were outstanding. The canoe came standard with a deep yoke, bootlace seats and iodized aluminum gunwales. Best of all, I can hoist it onto my shoulders with very little effort at all. No sense having a great canoe if you can't pick it up.
I am a strictly solo paddler. I like having a strictly solo boat so people don't ask to ride with me. I like to stand and paddle, and I like to pole. I like to kneel and I like to sit back and slack off. But there is nothing more uncomfortable to me than to be headed into rapids in a boat I can't turn. I've taken out various angling and recreational boats by very reputable companies, and I have been miserable because I can't spin them on a dime when I needed to. I'd give up every other criteria in order to be able to turn because it just feels unsafe. After 8-day tripping for a long time in a whitewater boat, this was something I just can't compromise.
The Prospector performed better than I had hoped. It actually paddles better with a load, still feeling light and agile even with a weeks worth of gear, a kid and a childs kayak riding on top. Tight for but doable. I'm a 33 yo woman, moderately fit, and even after 12-14 hour days on the water, 21 mile paddles, I didn't feel worn out at the end of the day.
It tracks pretty well, And it steers beautifully. Initial and secondary stability were very comfortable for me, and it allowed me to stand up through rapids to check on the kids progress, shout directions, or just stand up and stretch my legs through long flat sections. Handled Class I-III rapids wonderfully, and was truly a joy to ride.
The craftsmanship is truly impressive. It is a beautiful canoe, and the laced seats are gorgeous and comfortable. It is very easy to portage, and the lighter weight really made a difference when loading this boat solo over my head. The extra wide yoke and spine notch make it extremely comfortable to carry, as I found myself needing to carry this boat up hill about 100 yards. It was surprisingly easy.
We handled a pretty serious thunderstorm on the river, and I felt quite confident in high winds. The high gunwales do catch a lot of wind, and it does blow around, but it makes for a dry ride and it's difficult to dip a rail and swamp this boat, a trade off I'm happy to make.
All around, it tracks great in the flats, heels over great to paddle in the Canadian style, smaller rapids were fun, hauls everything and makes an outstanding kid wrangler. The only downside was the price, the only reason I gave it a 9- but I feel confident I'll have this boat for 25 years, and sometimes in life, you get what you pay for. I couldn't be happier with this canoe and I'd recommend it to anyone looking for something to do it all.
Other than the fact that I get a few more scratches on the bottom with the Prospector, it is faster and more stable than the OT Camper, as well as easier to solo. It is much faster and a more stable than the Fisherman, although more effected by the wind - and pretty much makes up for the lack of comparable maneuverability when leaned aggressively for tight turns (which is easy, due to the wonderful secondary stability of the Prospector).
Compared to the Old Town Penobscot, the NC Prospector gives up some speed and some tracking ease. The Prospector is a little better in secondary stability - but not much. It is more effected by wind than the Penobscot, since the Penobscot has a lower profile and very little rocker. But the Prospector is much drier in the rough, due to it's rocker, it's fuller stems, and higher profile - and easier to turn, also due to it's moderate rocker.
If I had to limit myself to one tandem canoe in the ~$1400 and under price range, it would be a tough decision between the Prospector and the Penobscot. The Penobscot is the better flat-water boat, but the Prospector is better for the rougher stuff. I consider them both to be among the better, if not the best, all-around Royalex canoes - with each leaning slightly to opposite ends of the spectrum but considerable overlapping in their range of suitability. Both boats can be poled easily (the Prospector, more easily climbs drops because of it’s rocker), and both can be paddled solo with relative ease. Both are well-constructed and show little or no "oil-canning." Fortunately, I don't have to choose. I do believe that you can cover most general tandem canoe needs with these two boats - as long as you can stand the weight.
Weight is more of an issue here, since my Prospector is the "standard" (heavier) Royalex lay-up. Wouldn't have been my first choice if I was buying new at list price, but mine was left-over stock and I got a great deal on it. This heavier (74lbs) lay-up has shown to be really tough though. Although the bottom is now pretty much covered with surface scratches and a few small dings, it seems to be holding up to my rough treatment with no sign of any damage that might need attention. It as taken some practice - but I find that I can lift and carry the boat by myself pretty well, so long as I don't have to carry it far. The contoured Nova-Craft yoke really helps in that.
My wife and I are still "novice" paddlers, in my estimation. We haven't done anything bigger than higher class 1 tandem, so I can't speak to tandem whitewater performance. But we find the Prospector to be confidence-inspiring and easy to handle in tricky river current. We are learning tandem eddy-turns, peel-outs, back-ferries, and such with no real difficulty in this boat. I have done some cl2 water solo with paddle and with pole, and find it well-suited for that. This is now my primary poling canoe and will likely remain so until I replace it with a lighter composite. I'm not sure if we will go with a composite Prospector at this point, but that is highly likely.
I really like the Nova-Craft seats. They are comfortable and easy to maintain/repair - and they are quiet (no squeaking, as we've seen with the seats on several other caned or laced canoe seats). I also like the fact that Nova-Craft puts grab loops through "tug-eyes" on their boats. And the yoke gets not one, but two bolts on each end into the gunnels. Great construction. Built to last. Although I know it saves some weight - I would prefer not to have the simple individual seat drops, but would rather have "truss style" drops for added rigidity. The Nova-Craft seat drops are more substantial than those that came on my Old Town canoes though, being heavier rectangular stock rather than simple round dowels. Recently, I added a kneeling thwart in the place of the standard thwart ahead of the rear seat - and eventually, I will replace the stock seat drops with truss drops. So my Prospector might be a couple pounds heavier than stock, but I think it will be worth it.
So - if you plan to spend most of your time on moving rivers cl1+ to at least cl2 (and probably a bit higher) the NC Prospector is easily up to the task. Probably one of the best all-around tandem designs for moving and twisting water. Not so much for lakes and other big flat water, although competent there as well (especially with a load). I give this canoe a 9 - only because of the seat drops and because the Nova-Craft Blue Steel composite version should be every bit as good or better in every respect (except the higher price) - with less than 2/3 the weight.
I would rate this canoe a 9.5/10 as is and if I could afford a custom build, to add a few minor changes I would give it a full 10/10. If you can only afford one canoe and you want it to do everything and last a life time, buy the Nova Craft Prospector.
This boat strikes me as handling and tracking pretty well, but I was testing it solo, with no load on a windy day and a shallow lake, so I had to work to control it. I imagine it would be much easier to steer with a bow paddler and even a light load.
Nova Craft is probably the best Canadian canoe maker and is upping its profile in the US canoe market, and runs with Mad River and Wenonah. Nova Craft is already miles ahead of Old Town in its boats. Nova Craft has designed some good hulls, including the hi-tech Retro Chestnuts, Bob Special and Prospector, and makes a good fit and finish boat. The Royalex Lite is a nice compromise for those who want Royalex's durability but not its heavy weight.
I am a little confused whether the NC Prospector 16 in Royalex Lite weighs 59 lbs. or 64 lbs.? I have seen it advertised at both weights, and the seller whose boat I tested told me 64 lbs. I was able to handle the boat better than my 75-80 lb. Explorer 17, and to get it up over my head and onto a car, so even if it is 64 lbs., it is quite a bit lighter than the Explorer, which is made of full thickness, bomb-proof, Royalex.
Plus, my seller's boat had vinyl gunnels and skid plates, which he puts on all his boats, standard and which add a pound or two to the weight. I do not know if you need skid plates initially on a Royalex Lite boat, especially if you do not plan to drag over or run into a lot of rocks.
At any rate, I am going to buy one of these boats and highly recommend it for all uses on lakes and rivers, based on my two test-paddles.
No, it is not as quick and nimble as the Bell, nor will it haul 1500 lbs like the XL, but it will hold its own quite respectfully in all conditions. I have been solo and light playing at different angles to the wind and actually got it to sail up wind with it heeled over to the lee side. This boat does not let me down in any aspect.
The most surprising thing about it was how comfortable it was to portage. I have fun with the other boats, and enjoy each ones special purpose, but when I don't know what to expect, I take the prospector. I can't recommend it enough. Only downer is the stupid rope pulls in the bow and stern. The dealer in Cabin John, MD gave me the best deal.Have fun, be safe, go far, u can do with this boat.